Description
2 Roller Auto-Hydraulic Plate Rolling Machine 2 rolls plate rolling machine
Prima Two rollers cnc rolling machine is a new series device. On the device, the up-roller is steel
roller, and the bottom roller inside is steel roller with outside elastic layer. When operate device, feed the plate between the two rollers, and adjustment the distance of the two rollers. Let them connect—down pressure—bottom roller deformation, drive the two rollers, so the plate continuous coiled into a shape. This device with some advantages like as, one time coiled into a shape, high efficiency, high geometry accuracy, good surface without scratching, simple structure with only 2 rollers, operate easily, it easy to realize cnc operation procedure.
This device widely used in ventilation pipe, chimney, filter, solar water heater, automobile exhaust, motorcycle muffler and so on for the thin thickness plate.
- Main specification
- The width of the rollingplate:100-1600mm
- The max thickness of the plate:0.1-10 mm carbon steel ( 0.5-5mm Stainless Steel 304 and 321)
- The material of plate:carbon steel, Stainless Steel 304 and 321
- The diameter of the rolling plate:according to customer’s requirements
- The input power: 380V/50HZ
- The main motor power:depends on model
- The hydraulic motor power:depends on model
- The normal work pressure of hydraulic system:6-8Mpa
- The Auto-hydraulic ability: manual feedingand automatic bend
- The bend process should be 25seconds, but a total work process should with feeding and
discharge is excepting.
- The temperature of work environment:-5℃~45℃
- Main characteristic
- This device use manual feed, and the weld gap’s size of the workpiece decided by the
steel material.
- If steel plate cutting accuracy and right use sheet alignment device, the workpiece’
dislocation is less than ±0.1mm.
- The roundness of workpiece in the range of 0.2%×workpiece diameter.
- With high work efficiency, straight edge it’s very small. The thin plate without straight
edge.
- The workpiece diameters’size decided the bend time, but about 2 workpieces per minute.
- Must to keep bottom roller clean, without oil stains.
- Executive Standard 《Q/320621BBD 01 2011》.
- #metal bending machine dies
#metal tube bending machine #rolling plate bending machine #3 roller plate bending machine