how to use hydraulic ironworker machine how to use punch and shear machine
hydraulic combined punching&shearing machine can cut and punch all kinds of materials such as plate, square bar, angle, round bar,
channel and so on.Prima hydraulic ironworkers have been designed and built to the highest quality standards in the industry.
This profitable machine will serve any grueling fabrication shop for decades to come. This machine is typically in stock for quick deliveries.
Ironworker machine in the industrial cutting is very widely used, cutting precision, simple and convenient. But do you know how to operate the
ironworker machine sprun? In fact, there is some preparation that is essential before the ironworker machine work. Next, let the small editor to introduce to you.
Guide to how to use the ironworker machine
Hydraulic ironworker machine test when the operation step micrometer fastened to the slider, so that the micrometer above the head on the angle dispensary
inspection surface. As the slider moves down, check on the two vertical biases.
The reading difference on the millennium meter is the vertical error travel length of 25 to 50mm0.04 to 0.08;
When the slider moves down, test on the two vertical biases. The reading difference on the millennium scale is the error of parallelity, the travel length of the trip
is 25mm s 25mm to 50mm and 0mm to fasten the chidofer on the outer end of the upper tool frame, so that the chiameter measures the head of the head;
Vertical support surface that fits with the lower blade, check the reading difference on the millennium table when the tool holder moves down, the error shear
thickness of parallelity is 10mm at 100mm travel length, and the cut thickness is 10mm at 100mm travel On the length; the hole that tightens the punch on the punch gripper,
the parallelity of this middle line to the slider movement is 0.040.060.08; the vertical support face that fits the lower blade; the parallelity of the movement
of the upper blade; 0. 05 to 0.160.05 to 0.24 Note: When the upper blade moves down, the distance between the two verticals that fit the upper and lower blades;
On the vertical support surface that fits the upper blade; check when the upper tool holder moves down. The reading difference on the micrometer is the difference
between the error shear thickness of the parallelity of 10mm at 100mm, and the trip length is: cut thickness of 10mm in the 100mm travel length:
the ironworker machine uses a stopper to check the gap between the two ends of the blade;
The difference is the error of parallelity. Hydraulic ironworker machine working principle of the ironworker machine, the upper blade fixed on the knife frame,
the lower blade fixed to the bottom bed surface, the bed surface is installed with a tonic ball, in order to facilitate the plate feed into the movement, the rear
bezel is used for plate positioning, the position is adjusted by the adjuster pin. The hydraulic pressure cylinder is used to press the plate material to prevent
the plate from flipping during shearing. Sheds are safety devices to prevent work-related accidents.
(1) Adjust the front bezel to the rear bezel tight down the knife, and then the model tight back to the rear bezel, the front bezel tight lyson and fixed.
Release the rear bezel, remove the template, install the plate material, cut.
(2) After adjustment bezel will be the model to level the next knife, and then the rear bezel tight lysing and fixed, remove the model,
and then installthed the plate material for cutting.
(3) Adjust the angle bezel first put the model on the counter alignment under the knife, adjust the angle bezel and fixed, and then adjust the
bezel according to the model adjustment bezel, cutting process at the same time use the angle bezel and the rear bezel to position.