Method for correctly installing metal plate fiber laser cutting machine lenses
metal plate fiber laser cutting belongs to mechanical equipment and requires strict requirements during use. One crucial component of the left and right metal plate fiber laser cutting effect is the installation of the metal plate fiber laser cutting machine lens. If this component is not installed according to the prescribed steps, it is easy to cause deviation in the cutting center or even misalignment of the cutting machine groove edge. So what aspects should be paid attention to when installing metal plate fiber laser cutting machine lenses?
Step 1: Before operation, please clean your hands thoroughly, and wash them with soap or detergent. This is a good habit for operating the cutting machine lens normally. Do not directly use bare hands to contact the lens. Gloves should be worn to prevent finger marks from affecting the lens.
Step 2: When placing the lens, attention should be paid to its stability to prevent slipping and damage, and at the same time, attention should be paid to placing the convex surface of the lens flat on a stable and clean desktop. At the same time, pay attention to checking the desktop for debris to avoid confusion or affecting the operating environment of the lens.
Three steps: The metal plate fiber laser cutting machine lens should be cautious of getting wet, and traditional blowing methods should not be used to wipe the lens, nor should hot air be used to blow the lens together to avoid damaging the lens due to sudden changes in heat. The lenses belong together, and the temperature and humidity are strictly controlled to avoid affecting the surface protective film and optical accuracy of the lens.
Four steps: After assembling the lens of the metal plate fiber laser cutting machine, pay attention to the cleanliness and dust removal of the lens. Use a clean air spray gun for cleaning, not a regular spray gun.
Five steps: The cutting machine lens must be kept clean, and do not touch the surface of the lens directly with your hands. Strictly prevent other non designated items from directly contacting the lens surface. The wiping paper used in lens cleaning and maintenance should be gently pulled from side to side to avoid scratching the surface of the lens.
